Serial cable constructed using 28 AWG wire about 15 cm long, Molex connector housing and four Dupont male jumper pins
Serial cable constructed using 28 AWG wire about 15 cm long, Molex connector housing and four Dupont male jumper pins

Serial Cable for CEF168 Lens Control Board

£2.00

The cable is constructed using 28 AWG wire and is approximately 15 cm in length. One end features a single Molex connector housing, while the other end terminates in four individual Dupont female jumper pins.

The cable is constructed using 28 AWG wire and is approximately 15 cm in length. One end features a single Molex connector housing, while the other end terminates in four individual Dupont female jumper pins.

EF / EF-S Lens Controller & Adapter for Raspberry Pi® High-Quality Camera – Canon® Lens Compatible
EF / EF-S Lens Controller & Adapter for Raspberry Pi® High-Quality Camera – Canon® Lens Compatible
£85.00
EF / EF-S Lens Controller & Adapter for Arducam® IMX708 Camera Module – Canon® Lens Compatible
EF / EF-S Lens Controller & Adapter for Arducam® IMX708 Camera Module – Canon® Lens Compatible
£87.00

The serial cable required to connect the lens controller via the serial port is sold separately. This cable is only necessary if you plan to integrate the adapter with industrial or astronomy cameras that use serial communication for lens control.

If you intend to use the control board exclusively with a Raspberry Pi camera, which communicates via the I²C bus and CSI connector, the serial cable is not required.